Ok, let's briefly talk fabric options for this project. Charmeuse satin is the way to go. It comes in silk or synthetic (polyester). Charmeuse is different than regular satin in that it's thinner and more delicate. It's the stuff they use to make lingerie, ladies. Of course real silk is nicer, but more expensive. Granted, it doesn't take a lot of fabric to make a garter, so even if you used real silk, the project cost would stay low. As for polyester charmeuse, I have come across some pretty good qualities, all from this place here. They only have a few colors listed online, but if you go to their Houston location they have over a hundred different colors of both higher quality polyester and heavenly silk charmeuse. LOVE that store.
Materials:
- 30"x5" rectangle of charmeuse for outer trim of "keep" garter
- 30"x4" rectangle of charmeuse for outer trim of ""toss" garter
- 2 cuts of 30"x 1 3/4" rectangle of charmeuse for center of each garter
- * 2 pieces of 3/4" wide non-roll elastic: 15" long
- Embellishments (bows, charms, beads, flowers, etc) - optional
For this tutorial, I'm only going to make the "keep" garter. The instructions for the "toss" are pretty much the same. I've used two different colors 1) because I love the fun contrast and 2) it's easier for ya'll to follow along in the tutorial.
Step One:
With right sides together, sew the long sides of the 30"x 5" cut of outer trim (blue) to the 30"x1 3/4" center fabric (black) using a 1/4 inch seam allowance.
(Note: It is important that you use a small 1/4 inch seam allowance and tiny millimeter top stitch (in below step), otherwise your elastic will not fit in its casing.)
Step Two:
Repeat for other side.
Step Three:
Turn right side out so you have a tube. Using low to medium heated iron, center the tube of charmeuse as desired. For the "keep" garter, I pressed it so the ruffle on bottom is longer than the top. For the "toss" garter, I press it dead centered.
(WARNING: polyester melts... no high heat or steaming unless you want to risk a shriveled plastic mess. Silk is a natural fiber and does not melt, but rather burns and should be pressed at a low heat as well.)
Step Four:
At one end of the tube, tuck and press in approximately 1/2 inch.
Step Five:
Top stitch about a millimeter in along each side of the center part of the tube. On the end that you tucked and pressed, DON'T top stitch.
Step Six:
Insert elastic. An easy way to do this is put a safety pin on one end of the elastic and work it through the tube. Push the charmeuse tube well into the center so you have both ends of the elastic hanging out for ease of sewing together.
Step Seven:
Sew the elastic. Make sure you don't have your elastic twisted. Overlap the elastic approximately one inch and sew a nice square and diagonal to to secure it.
Step Eight:
Tuck the raw end of the tube into the nice pressed end. Hand blind stitch closed or machine stitch close to the edge. This will be the back of the garter. Now give it a good stretch to distribute the gathers evenly.
Step Nine:
Leave as is or embellish as you see fit with a bow, flower, lace or beads. Oh, and add a "Keep" and "Toss" tag so the bride knows what the heck you're giving her. If you don't, she may just think you gave her a fancy baby headband ;)
